πŸ”§ Speaker Build β€” Bench Checklist

Unpack a box β†’ find its part below β†’ check it off β†’ it tells you which step it feeds.
βœ” Do first β€” shop-inspection. Before cutting anything, unpack every part and lay it out. Tap each driver gently (rattle-free), confirm the crossover board/parts are separate, and count ports, binding posts and bags. Finding a missing part now saves a lunchtime trip to the store later.

Phase 1 β€” Wood (cut the box)

You'll need brand-new out of the truck:

1
MDF sheet β€” 3/4" Γ— 4' Γ— 8' (Home Depot)
Cuts BOTH cabinets. Use the build guide's panel cut list & the full-size templates.
2
Wood glue (Titebond) + #6/#8 wood screws
Every butt joint gets glue; screws clamp while it dries.

Phase 2 β€” The drivers (mount on the front baffle)

These are the stars. Handle by the frame, never the cone/dome.

3
Woofer Γ—2 β€” Dayton DC160-8 (2 shipped separate)
Mounts in the LARGE front-baffle circle (5.69" cutout). Flange sits flush in the recess. Kept clear of the inductor in step 7.
4
Tweeter Γ—2 β€” Dayton DC28FS-8 (or DC28F-8)
Mounts in the SMALL circle (2.91" cutout) at the top of the baffle, above the woofer.

Phase 3 β€” Crossover & wiring (connect the electronics)

Only touch these AFTER the box is glued solid (steps from the guide).

5
Crossover β€” Option B: 2 Γ— Dayton XO2W-2.5K board … or Option A: the loose inductor + 2 caps + resistor per speaker.
Either way it's the same job: wire amp terminal β†’ crossover β†’ drivers. Keep the coil away from the woofer magnet; solder all joints.
6
Binding posts Γ—2 β€” gold 5-way pair (each cabinet: 1 pair, 2 posts)
Fits the two 0.44" holes in the BACK panel. This is where your amp cable plugs in.
7
Hookup wire + solder + lugs (hardware store)
One run postsβ†’crossover, one run crossoverβ†’each driver. Keep +/βˆ’ consistent on every driver.

Phase 4 β€” Port & damping (tune & quiet the box)

8
Port Γ—2 β€” Precision Port 2" flared tube kit (each cabinet: 1)
Tube length ~8" for the ~45 Hz tune. It slides into the 2.10" back-panel hole from the inside. Leave a clear straight run β€” nothing jammed in front of it.
9
Cabinet damping β€” Acousta-Fill 1 lb (1 bag does both if you split it)
Loosely fluffed inside β€” NOT packed. Must not block the port mouth or touch the woofer cone travel.

Phase 5 β€” Finish & stand

10
Rubber feet Γ—8 (hardware store) + optional paint/vinyl
Feet keep the box off the shelf & stop it ringing the surface. Paint/vinyl + seal the seams last.
πŸ”Š Done = test. Match +/βˆ’ on every driver, play a slow frequency sweep (you can find "sine sweep" clips free online), and listen for buzz at the ports or rattles. If it's clean β€” they're done. To tune the bass to your taste you can shorten the port tube a little (raises tune) after listening.